362
Programming Manual
Program 90: Maintenance Program
90-10: System Alarm Setup
IN
SA
SB
Default(Cont’d)
Alarm Type Report Note Is Used To Advise of…….. Action
10 0 0 ISDN Link Error
11 0 0 CTI Link Error
12 0 0
ACD-MIS Link
Error
13 0 0 TMR Link Error
14 0 0
EXIFU-LAN Link
Error
15 0 0 -Not Used- - -
:: : :
29 0 0
TRM output Buffer
Full
30 2(MIN) 0
SMDR output
Buffer Full
The SMDR Buffer is Full
Check the printer for the
SMDR.
31 0 0 -Not Used- - -
:: :
49 0 0 -Not Used- - -
50 1(MAJ) 0 System Start Up
51 0 0
System Data
Change
52 0 0 VM/HD
53 0 0 -Not Used- - -
:: : -Not Used- - -
100 0 0 -Not Used- - -
Conditions
None
Feature Cross Reference
None
Telephone Programming Instructions
To enter data for Program 90-10 (System Alarm Setup):
1. Enter the programming mode.
2. Enter 90 10
3. Enter the number of the item you want to program.
4. Select the Alarm number to be programmed by pressing the FLASH or the VOLUME▲ or VOLUME▼ keys.
5. Enter data for the item you selected + HOLD.
6. Enter data for the next item in the program.
OR
Press DC once to enter a new item number.
OR
Press DC until you’ve exited that series’s programming section
90-10-01Alarm1
larm Type 2
90-10-xx
xxxxx
To Next Page
Loading...
