378
Program 92: Copy Program
92-01: Copy Command
Programming Manual
IN
SA
SB
2. Trunk Group Base
Prog.No. Program Name Note
35-03
SMDR Port Assignment for Trunk Group
3. Extension Base
Prog.No. Program Name Note
15-01
Extension Basic Data Setup (include Virtual
Extension)
Copy all data except extension name(15-01-01)
15-02
Multi-Line Telephone Basic Data Setup
15-03
Single Line Telephone Basic Data Setup
15-06
Trunk Access Map for Extension
15-07
Programmable Function Key
15-08
Incoming Virtual Extension Ring Tone Setup
15-09
Virtual Extension Ring Assignment
15-10
Incoming Virtual Extension Ring Tone Order
Setup
15-11
Virtual Extension Delayed Ring Assignment
15-12
Conversation Recording Destination for
Extension
20-06
Class of Service for Extension
21-02
Trunk Group Routing for Extensions
21-04
Toll Restriction Class for Extensions
21-11
Hotline Assignment
23-03
Ringing Line Preference
23-04
Ringing Line Preference for Virtual
Extensions
24-03
Park Group Assignment
31-02
Internal Paging Group Assignment
4. Department Group Base
Prog.No. Program Name Note
16-01
Department (Extension) Group Basic Data
Setup
Copy all data except Group Name (16-01-01).
35-04
SMDR Port Assignment for Department
Group
5. DSS Console Base
Prog.No. Program Name Note
30-03
DSS Key Assignment
Conditions
Using this program to copy a keyset’s Programmable Function Keys will copy all the keys whether they exist on the
phone to which the programming is being copied. This may cause confusion when trying to define a key which is
already defined but which doesn’t exist on the phone (will display as “DUPLICATE DATA”). It is recommend to
either clear these non-existent keys or to only copy from an extension which has the same or fewer number of keys
than the extension to which the programming is being copied.
To Next Page
Loading...
