85
Program 14: Trunk Basic Setup
14-01: Basic Trunk Data Setup
Programming Manual
IN
SA
SB
COP
Input Data(Cont’d)
Prog. No. Item Input data Default Related Program
14-01-18
Warning Beep Tone Signaling 0 : Disable
1 : Enable
0
14-01-19
Privacy Mode Toggle Option
Use this option to enable or disable
a trunk’s ability to be switched
from private to non-private mode
by pressing the line key or Privacy
Release function key.
0 : Disable
1 : Enable
0
14-01-20
Block Outgoing Caller-ID
Allow (0) or Block (1) the system
from automatically blocking
outgoing Caller ID information
when a user places a call. If
allowed (i.e. block, enabled), the
system automatically inserts the
Caller ID block code (defined in
14-01-21) before the user dialed
digits.
0 : Allow
1 : Block
0
14-01-21
Caller-ID Block Code
Enter the code, up to 8 digits, that
should be used as the Caller ID
Block Code. This code is
automatically inserted before
dialed digits if Program 14-01-20 is
set to ‘1’.
0 : Dial (Up to 8 digits)
1 : Enable
No
setting
14-01-22
Caller-ID to Voice Mail
Enable or disable the system’s
ability to send the Caller ID digits
(Remote Log-On Protocol) to voice
mail.
0 : Disable
1 : Enable
0
14-01-23
Least Cost Routing 0 : LCR Off
1 : LCR On
2 : LCR On (Cost Center
Code only)
026-01-04
26-05 to 26-08
Default
14-01-01: Trunk Name
Trunk Port Number Name
1Line 01
2Line02
::
51 Line 51
Conditions
None
Feature Cross Reference
Refer to feature in above chart.
To Next Page
Loading...
