NEC UNIVERGE NEAX 2000 IPS - Page 115

– 91 – NWA-008844-001 Rev.5.0
91ch3001.fm
COMMAND CODE
TITLE:
BASIC SERVICE FEATURES
08
: Initial Data
BASIC SERVICE FEATURE SETTING DATA
046 Warning Tone sent to connected parties to alert Executive Right
of Way, Busy Verification or Attendant Override
• Three burst tone [Other than New Zealand]
• One burst tone [New Zealand Only]
0
1
Not sent
To send
048 Passing Dial Tone facility 0
1
Not available
Available
050 If the * button on a DTMF telephone is pressed while hearing
busy tone, it is regarded as a Switch Hook Flash
0
1
Effective
Ineffective
051 If the # button on a DTMF telephone is pressed while hearing
busy tone, it is regarded as a Switch Hook Flash
0
1
Effective
Ineffective
055 Result of a Switch Hook Flash on a telephone which belongs to
House Phone Group 0 or 1
0
1
Special Dial Tone
(Dialing is available)
Attendant Recall
056 Result of a Switch Hook Flash on a telephone which belongs to
House Phone Group 2 or 3
0
1
Special Dial Tone
(Dialing is available)
Attendant Recall
057 Result of a Switch Hook Flash on a telephone assigned as a Hot
Line
0
1
Special Dial Tone
(Dialing is available)
Attendant Recall
062 Call transfer from a station before a called station answers 0
1
Not available
Available
063 Call transfer from a station before a called attendant answers 0
1
Available
Not available
064 Reverted Call Metering
[Australia Only]
0
1
Available
Not available
067 Automatic Change of Night Service (Attendant Overflow) 0
1
Available See CM30 Y=03
Not available
068 Camp-On Tone sending to a busy station by Camp-On 0
1
Send out only once
Repeat at 4 seconds intervals
069 When a station user has dialed any one digit while hearing busy
tone
0
1
Switch Hook Flash
Step Call
070 Line Fault Detection (Line disconnection or short circuit)
[Australia Only]
0
1
To provide
Not provided
Continued on next page
JULY/01/2006
CM08