– 104 – NWA-008844-001 Rev.5.0
91ch3001.fm
COMMAND CODE
TITLE:
BASIC SERVICE FEATURES
08
: Initial Data
BASIC SERVICE FEATURE SETTING DATA
222 To complete the operation for setting Call Forwarding-All
Calls-Outside/Busy Line-Outside/Do Not Answer-Outside
0
1
Setting when the station goes on
hook/when receiving Service Set
Tone (ORT time out)
Setting when receiving Service Set
Tone (ORT time out)
227 Whether the transferred C.O. call from station or attendant is
placed into queuing mode when all ACD/UCD stations are busy
NOTE: Effective only when CM08>212 is set to 1.
0
1
The call is placed into queueing mode
Recall to the transferring station when
the call is transferred from station, or
Attendant Camp-On is set when the
call is transferred from Attendant
228 Ringing start time for Wake Up call/Timed Reminder call 0
1
Start at preset time
Start at the time 5 minutes before pre-
set time
229 Choice of Night Service via ATTCON Programming Mode 0
1
Available
Not available
232 Trunk access from station in Room Cutoff status 0
1
Restricted to C.O. only
Restricted to all Trunk Route
233 Message Waiting lamp of calling station is extinguished when
an attendant answers
0
1
Available See CM13 Y=13
Not available
234 Message Waiting/Message Reminder is reset (turning the MW
Lamp off) irrespective of answering of calling station when the
called station calls to retrieve the message
0
1
Available
Not available (Reset by answering of
calling station)
235 Message Waiting/Message Reminder is reset (turning the MW
Lamp off) by answering at the called station when the calling
station calls again after setting this feature
0
1
Available
Not available
(As per CM08>234)
236 Special Dial Tone sending for Attendant Console or station dial-
ing a Message Waiting access Set/Cancel code
0
1
Not tone
Tone is sent
237 Automatic Intercom to station set for Do Not Disturb 0
1
Restricted (ROT connection)
Allowed
238 Ringing of Manual Intercom call on station set for Do Not Dis-
turb
0
1
Not ring on
Ring on
Continued on next page
JULY/01/2006
CM08
To Next Page
Loading...
