– 111 – NWA-008844-001 Rev.5.0
91ch3001.fm
COMMAND CODE
TITLE:
BASIC SERVICE FEATURES
08
: Initial Data
BASIC SERVICE FEATURE SETTING DATA
367 Camp-On (Call Waiting) Tone sent to busy station by Call Wait-
ing-Station/-Terminating (Camp-On Call Waiting method)
NOTE: In Italy, Belgium, Denmark, Switzerland and Spain, you
have to set setting data to 0.
0
1
Every 4 seconds
Only once
Camp-On (Call Waiting) Tone sent to busy station by Call Wait-
ing-Station/-Terminating
[New Zealand Only]
0
1
Only once
Every 2 minutes
368 Centralized Billing-CCIS for Center Office 0
1
To provide (for Center Office)
Not provided (for Local Office)
369 Automatic return of originating station to the held C.O. line
call, after the inquiry call is disconnected.
0
1
Automatic return to C.O. line call
Return to C.O. line call via hooking,
when receiving ROT
370 Call Forwarding-Outside-CCIS on incoming call from CCIS 0
1
Restricted
Allowed
371 Call Forwarding Override-CCIS 0
1
Not available (BT connection)
Available
372 Alternative Routing when outgoing trunks of tandem office are
all busy/Alternate Routing for multiple IPT/SIP cards
0
1
Available
Not available
373 Send Call Forwarding station information through CCIS 0
1
To send
Not sent
376 When forwarded call is terminated to VMS via CCIS, whether
Message Waiting from VMS is provided for the called station
0
1
To provide
Not provided
377 Send calling party information to SMDR on CCIS tandem calls 0
1
Station number and Office number
Trunk Route number and Trunk num-
ber
378 Centralized Billing-CCIS for Local Office 0
1
To provide (for Local Office)
Not provided (for Center Office)
379 Maximum number of dialed digits sent to the CCIS 0
1
24 digits
15 digits
When a call is terminated via CCIS/SIP, whether Caller ID Dis-
play/Name Display (Attendant Called/Calling Name Display) is
provided for the called station.
0
1
To provide
Not provided
Continued on next page
INITIAL
DECEMBER/02/2005
CM08
To Next Page
Loading...
