– 242 – NWA-008844-001 Rev.5.0
91ch3002.fm
COMMAND CODE
TITLE:
STATION NUMBER, TRUNK NUMBER, CARD NUMBER FOR EACH FP
14
Continued on next page
1ST DATA 2ND DATA
RELATED
COMMAND
DATA MEANING DATA MEANING
XX ZZZ XX : FP/Virtual AP No.
(00-63)
ZZZ: AP/Virtual PIM
Port No. (000-127)
E201
E215
Card number of PB receiver (PN-8RST)
NOTE 1: The card number (E201-E215)
should be assigned to the FP No. 00-
03 as follows.
For FP No. 00: E201-E203
For FP No. 01: E204-E207
For FP No. 02: E208-E211
For FP No. 03: E212-E215
NOTE 2: For the FP No. 04-31, the card num-
ber can be assigned to without limit
as shown above NOTE 1.
NOTE 3: The card number (E201-E215) is
dedicated to PB receiver when a
system is not provided Remote PIM
over IP or a system is a Main Site of
Remote PIM over IP.
NOTE 4: The card number (E200) is dedicat-
ed to built-in PB receiver when a
system is not provided Remote PIM
over IP or a system is a Main Site of
Remote PIM over IP. (Assignment
by CM14 is not required.)
NOTE 5: The card number (E216-E230) is
dedicated to built-in PB receiver
when a system is a Remote Site of
Remote PIM over IP. (Assignment
by CM14 is not required.)
NOTE 6: A maximum of 4 PB receiver num-
ber (including built-in PB receiver)
can be used per FP card when a sys-
tem is not provided Remote PIM
over IP or a system is a Main Site of
Remote PIM over IP.
NOTE 7: One PB receiver number (built-in
PB receiver) can be used for each
Remote Site when a system is a Re-
mote Site of Remote PIM over IP.
[Series 3200 R6.2 (R6.2)]
CM45 Y=0, 1, 2,
9
~
CM14
To Next Page
Loading...
