CHAPTER 2 PRECAUTION
– 26 – NWA-008844-001 Rev.5.0
91ch2001.fm
Conditions for Using Commands
NOTE 1: Before the MP card is reset, the system data backup must be executed by CMEC Y=6>0:0.
NOTE 2: A reset is not required after setting/changing CM04 Y=00, CM12 Y=17, and CM35 Y=100,
when using Series 3600 software or later. These commands are valid by the following opera-
tions respectively after setting/changing.
• CM04 Y=00 : pull out and reconnect the modular connector of the D
term
and DLC card
• CM12 Y=17 : pull out and reconnect LLC card
• CM35 Y=100: pull out and reconnect COT/IDT/LDT/ODT/DID cards
Continued on next page
CONDITION COMMANDS MEANINGS
Commands which require a
reset of the MP card after
data setting.
• Press SW1 on the MP
card for system reset.
NOTE 1
CM31 Y=0, Y=1>1, 2, 3,
Y=2, Y=3, Y=4, Y=5,
Y=6, Y=7, Y=8, Y=A>00,
01, 02, 04, 05, 06, 07, Y=B
MFC/MF-ANI Trunk Data
CM35 Y=90, 91, 100
NOTE 2
Trunk Route Data
CM42>47, 48, 66, 68, 74,
75
System Counter Data/Pad Data/Trunk
Restriction Class Conversion
CM48 Y=0: 0200, Y=1:
0200, Y=2>09-11, Y=4
Hold/Walk Up/Timed Reminder/Automated
Attendant Tone
CM5A Virtual Line-Virtual Trunk Path Setting
CM60 Y=00, 01, 02, 04,
06, 16, 17, 22, 23, 27, 51
ATT Tenant Group, Functions
CM62 Tenants for Each ATT Group
CMA0 Type of Data Terminal Interface
CMA7 Originating Point Code (OPC) of CCH/IPT
CMAA Y=14 Selection of DCH/CCH/DTI for T1, VIR-
TUAL AP Function
CMAC ISDN Functions
CMF8 Y=3>0, 1 Serial No./ID Code/Program Revision Read
INITIAL
JULY/01/2006
CONDITIONS FOR USING COMMANDS
To Next Page
Loading...
