NEC UNIVERGE NEAX 2000 IPS - Page 532

– 508 – NWA-008844-001 Rev.5.0
91ch3005.fm
COMMAND CODE
TITLE:
LOCATION DATA ASSIGNMENT
67
: Initial Data
Y 1ST DATA 2ND DATA
RELATED
COMMAND
No. MEANING DATA MEANING DATA MEANING
06 Diffserv Code
Point (DSCP) of
control packet and
voice packet
[Series 3200
R6.2 (R6.2)]
XX ZZ XX: Location
number of
group (00-63)
ZZ : Location
number of
group (00-63)
XX ZZ
NONE
XX: 00-FF: DSCP of
control packet
ZZ : 00-FF: DSCP of
voice packet
C0A0
CM12 Y=39/50
CM8A Y=5000-
5255: 173
CM0A Y=09
CM67 Y=01
NOTE 1: This data is required when the system is connected to the router that provides the Diffserv type QoS
function.
NOTE 2: This data setting is valid to the packets that are sent to the group which is set “ZZ” in the first data
from the group which is set to “XX” in the first data.
NOTE 3: The TOS field precedence that is set by CM67 Y=01 is invalid when this data is set. To be valid the
TOS field precedence, set CM67 Y=01 again after this data setting.
07 Whether the
D
term
IP at remote
site location from
IPS through NAT
can communicate
each other under
the same NAT or
not
[Series 3700
R12.1]
XX ZZ XX: Location
number of
group (00-63)
ZZ : Location
number of
group (00-63)
0
1
Under the same NAT
Under the different NAT
or Not used NAT
CM67 Y=08
NOTE: The same location number must not be assigned to D
term
IP that is not accommodated under the same
NAT. However, multiple location numbers can be assigned to D
term
IP that is accommodated under the
same NAT.
08 Whether the con-
nection between
locations is
restricted or not
[Series 3700
R12.1]
XX ZZ XX: Location
number of
group (00-63)
ZZ : Location
number of
group (00-63)
0
1
To restrict
Not restrict
CM67 Y=07
NOTE: Restrict the following connection by this command when NAT is used.
- Connection via CCIS (Peer to Peer connection)
- Connection between Main Site and Remote Sites
- Connection between locations that is restricted the communications
Continued on next page
JANUARY/20/2006
CM67