– 538 – NWA-008844-001 Rev.5.0
91ch3005.fm
COMMAND CODE
TITLE:
DIGIT CONVERSION ON DID CALL
76
: Initial Data
Continued on next page
Y
1ST DATA
2ND DATA
REMARKS
No. MEANING DATA MEANING
37 Distinctive LED
indication on
D
term
for DID
incoming call with
no CLI
[Series 3600]
000-999:
Number Conver-
sion Block No.
assigned by
CM76 Y=00/90
0
1
Green (120 IPM)
Red (120 IPM)
CM35 Y=32
CM76 Y=34,
36
NOTE: This command is effective on the following conditions.
• CM35 Y=32 is set to 1.
• CM76 Y=34, 36 is set to 0 or 2, and D
term
receives the incoming call.
38 Interval of
ringing tone for
DID incoming call
with no CLI
[Series 3600]
000-999:
Number
Conversion
Block No.
assigned by
CM76 Y=00/90
0
1
2
3
Ringing NOTE3
See CM08>397
Special Ringing
See CM08>397
Internal Ringing
See CM08>397
As per CM76 Y=22
[Other than North America]
CM08>397
CM76 Y=22,
34, 36
0
1
2
3
0.5 seconds ON-0.5 seconds OFF
(D
term
)
1 second ON-2 seconds OFF (SLT)
0.5 seconds ON-0.5 seconds OFF
-0.5 seconds ON-1.5 seconds OFF
(D
term
)
0.4 seconds ON-0.2 seconds OFF
-0.4 seconds ON-2 seconds OFF
(SLT)
1 second ON-2 second OFF
(D
term
or SLT)
As per CM76 Y=22
[North America Only]
NOTE 1: Assign this command when the terminal destination is SLT or D
term
.
NOTE 2: This command is effective when CM76 Y=34, 36 is set to 0 or 2.
NOTE 3: For SLT, Internal Ringing is applied. For D
term
, Special Ringing; 0.5 seconds ON-0.5 seconds OFF
[For Australia/Asia/Africa/Europe/Latin America/Middle East/Russia] or 0.25 seconds
ON-0.25 seconds OFF-0.25 seconds ON-0.25 seconds OFF [For EU] is applied.
NOVEMBER/15/2006
CM76
To Next Page
Loading...
