Set the wipeout correction for PDF
Introduction
The [Wipeout correction] for PDF setting allows you to print PDF documents, that contain solid
black areas that block parts of the image. When you enable this setting, PDF documents are
printed correctly but the processing of the PDF files is slower.
Procedure
1.
Open the [Preferences] - [Print job defaults] tab.
2.
Click [Edit] in the [PDF rasterisation settings] section, or click on the [Wipeout correction] setting.
3.
Enable or disable. The setting is enabled when you check the box.
4.
Click [Ok] to confirm, or [Cancel] to reject your entry.
Set the wipeout correction for PDF
Chapter 3 - Define your Workflow with Océ Express WebTools
155
To Next Page
Loading...
