Oce PlotWave 360 Operation Guide

Calibrate the scanner
Introduction
You can calibrate the scanner when you are not satisfied with the copy or scan quality. Use the
calibration wizard to calibrate the scanner.
Before you begin
Clean the scanner before you start the calibration procedure. Dirty parts of the scanner cause a
decreased copy and scan quality. For more information, see Clean the scanner on page 280.
Open the media drawer to find the scanner calibration sheet, at the back of roll 2. For more
information, see
The media drawer on page 29.
IMPORTANT
• Handle the calibration sheet with care.
• Do not touch the black area of the calibration sheet with your fingers.
• Before you use the calibration sheet, wipe off any dust from the calibration sheet.
Procedure
1.
Select the [system menu] thumbnail.
2.
In the menu list, in the bottom right part of the display you can see the tile [Scanner calibration].
3.
Tap the [Scanner calibration] tile. A wizard opens up.
4.
Follow the instructions in the wizard.
Calibrate the scanner
Chapter 5 - Maintain the Printing System
283

Oce PlotWave 360 Specifications

General

Print Technology	Océ Radiant Fusing technology
Resolution	600 x 1200 dpi
Maximum Media Width	36 inches
Print Speed	6 A1/D prints per minute
Media Handling	2 rolls
Warm-up Time	Instant On
Weight	195 kg
Media Width	Up to 36 inches