Oce PlotWave 360 Operation Guide

Replace the residual toner container
Introduction
A sensor detects when the residual toner container is full. When the container is full, the printer
stops printing and a message appears on the user panel: [The residual toner container is full or
not installed.] [Place the empty container.] Replace the container to continue printing.
NOTE
It is advised to replace the residual toner container every time you refill a complete toner bottle.
IMPORTANT
Do not replace the container during the printing process. You can replace the container when the
printer is on.
Procedure
1.
Open the residual toner compartment.
2.
Remove the full residual toner container.
Replace the residual toner container
278
Chapter 5 - Maintain the Printing System

Oce PlotWave 360 Specifications

General

Print Technology	Océ Radiant Fusing technology
Resolution	600 x 1200 dpi
Maximum Media Width	36 inches
Print Speed	6 A1/D prints per minute
Media Handling	2 rolls
Warm-up Time	Instant On
Weight	195 kg
Media Width	Up to 36 inches