Set the link speed and duplex mode
Introduction
Use Océ Express WebTools to set the transmission speed and duplex mode for your network
adapter.
Before you begin
NOTE
The list of values you can select depends on the network card type.
Procedure
1.
Open the [Configuration] - [Connectivity] tab.
2.
Click [Edit] in the [Network adapter] section, or click on the [Link speed and duplex mode] setting.
3.
Select the value. [Automatic detection] is default.
4.
Click [Ok] to confirm, or [Cancel] to reject your entries.
Set the link speed and duplex mode
Chapter 3 - Define your Workflow with Océ Express WebTools
161
To Next Page
Loading...
