Set the spool threshold
Introduction
When the job memory is full the printer cannot receive new jobs, therefore it is necessary to
spool the memory. Set the [Spool threshold] setting to define the spool capacity for your jobs.
You can choose one of following values:
• [Low]
Select this value when you have more small print jobs, and you want to allow a higher
capacity.
• [Normal]
This is the default setting. Select this value when you have both small and large print jobs.
• [High]
Select this value when you have more large print jobs, and you want to reduce the risk of
having to abort the file transfer due to a full job memory.
Procedure
1.
Open the [Preferences] - [System defaults] tab.
2.
Click [Edit] in the [Printer properties] section, or click on the [Spool threshold] setting.
3.
Select [Low], [Normal], or [High].
Select [Low] when print productivity is an important factor.
4.
Click [Ok] to confirm, or [Cancel] to reject your entries.
Set the spool threshold
158
Chapter 3 - Define your Workflow with Océ Express WebTools
To Next Page
Loading...
