Set the rotation mode
Introduction
When you want to turn an image you can use the rotation settings. The setting allows you to turn
the image according to predefined rotation values, or you can let the printer perform the rotation
automatically.
Choose one of the following values:
• [No rotation]
• [90°]
• [180°]
• [270°]
• [Auto rotate portrait]
• [Auto rotate landscape]
• [Auto rotate portrait with additional 180° rotation]
• [Auto rotate landscape with additional 180° rotation]
• [Auto rotate media saving]
• [Auto rotate media saving with additional 180° rotation]
Procedure
1.
Open the [Preferences]- [Print job defaults] tab.
2.
Click [Edit] in the [Layout] section, or click on the [Rotation] setting.
3.
Choose one of the values.
Select [Auto rotate media saving] or [Auto rotate media saving with additional 180° rotation]
when the print productivity is an important factor.
4.
Click [Ok] to confirm, or [Cancel] to reject your entries.
Set the rotation mode
Chapter 3 - Define your Workflow with Océ Express WebTools
159
To Next Page
Loading...
