Oce PlotWave 360 - Clear a Media Jam in the Roll Feed Section

Clear a media jam in the roll feed section
Introduction
When a media jam in the roll feed section occurs, follow the help wizard on the user panel and
take the following steps:
Procedure
1.
Firmly pull the media drawer to open it.
2.
Remove any jammed printing material from the paper path and, if necessary, pull back the media
and rewind it.
3.
Reload the media roll if necessary, and press the [clean cut button] to trim a strip of the media
roll.
4.
Close the media drawer.
Clear a media jam in the roll feed section
316
Chapter 8 - Support