Oce PlotWave 360 Operation Guide

Clear a media jam in the heater section
Introduction
When a media jam in the heater section occurs, you have to handle with care.
IMPORTANT
During normal use the fuser has to remain closed. Only open it to remove the media after a
media jam.
Procedure
1.
Wait a few moments to let the heater cool down.
2.
Use the media jam clearance handle to open the upper back cover.
Clear a media jam in the heater section
312
Chapter 8 - Support

Oce PlotWave 360 Specifications

General

Print Technology	Océ Radiant Fusing technology
Resolution	600 x 1200 dpi
Maximum Media Width	36 inches
Print Speed	6 A1/D prints per minute
Media Handling	2 rolls
Warm-up Time	Instant On
Weight	195 kg
Media Width	Up to 36 inches