Oce PlotWave 360 Operation Guide

Do a default scan job
Introduction
When you want to scan an original and you do not make any settings the default presets are
used. You only use the Smart Access to submit your job.
You can see the presets that are used in the job settings section of your job.
Procedure
1.
Feed the original face up and centred on the original feeding table.
2.
Select the Scan tile on the user panel. The scan Smart Access is visible.
3.
Select the preferred location in the Smart Access and tap the green button.
When you do not select a location the file is sent to the public Smart Inbox.
Do a default scan job
Chapter 4 - Use the Printing System
221

Oce PlotWave 360 Specifications

General

Print Technology	Océ Radiant Fusing technology
Resolution	600 x 1200 dpi
Maximum Media Width	36 inches
Print Speed	6 A1/D prints per minute
Media Handling	2 rolls
Warm-up Time	Instant On
Weight	195 kg
Media Width	Up to 36 inches