Restore the factory defaults
Introduction
Sometimes you want to go back to the initial settings. You can restore the factory default settings
in Océ Express WebTools.
NOTE
Log in as a Key Operator to only restore the Key Operator settings. Log in as a System
Administrator to only restore the System Administrator settings. To restore all the factory
default settings you must log in as a Power User.
Procedure
1.
Open the [Configuration] tab, or the [Preferences] tab.
2.
Click [Restore defaults] in the upper right hand corner of the screen. A window opens.
3.
Click [Ok] to restore the factory default settings, or [Cancel] to close the window without restoring
the factory defaults.
Restore the factory defaults
86
Chapter 3 - Define your Workflow with Océ Express WebTools
To Next Page
Loading...
