Oce PlotWave 360 Operation Guide

Setting Description
[Media source] Select the default output material and format for the media used
on the printer.
• Select [Automatic], to automatically select the media.
• Select [Manual feed] to insert a cut sheet.
• Select the specific roll number of the media you want to use by
default.
The system screen on the printer user panel displays the loaded
rolls.
NOTE
You can only configure the Media selection policy set-
ting, when Media source is set to [Automatic].
[Media selection policy] • Select [Automatic next larger] to allow the printer to use a me-
dia roll larger than the size of the print, when the exact size is
not available.
• Select [Automatic exact fit] to only allow the printer to use a
media roll that has the exact media size of the print. When the
media roll with the exact media size is not available a media re-
quest appears.
[Cut method] • Select [Standard] to cut the print at a standard media size (DIN,
ANSI etc.).
• Select [Synchro] to cut the print at the end of the image.
• Select [Custom] (numeric) to cut the print at a specific length.
[Custom print length] Enter the cut length of your print job.
[Add leading strip] When you enter a value, the printer adds a blank strip of the speci-
fied length at the top of the output.
[Add trailing strip] When you enter a value, the printer adds a blank strip of the speci-
fied length at the bottom of the output.
Overview of the [Print job defaults] - [Layout] settings
Open the [Preferences] - [Print job defaults] tab. Go to [Layout] and click edit in the upper right
hand corner.
Setting Description
[Scale] • Select [Automatic scale to the media size] to scale the image to
the media.
• Select [Automatic scale down when image is larger than media]
to scale down the image one format smaller than the original.
• Select [Custom scale factor] to enter your own scale percent-
age, with 100 percent as no scaling.
[Mirror] Select [On] to mirror the image along the vertical axis - the media
transport direction.
4
Set the print job default settings
88
Chapter 3 - Define your Workflow with Océ Express WebTools

Oce PlotWave 360 Specifications

General

Print Technology	Océ Radiant Fusing technology
Resolution	600 x 1200 dpi
Maximum Media Width	36 inches
Print Speed	6 A1/D prints per minute
Media Handling	2 rolls
Warm-up Time	Instant On
Weight	195 kg
Media Width	Up to 36 inches