Omron Sysmac NY-series

Relevant Manuals
The following table provides the relevant manuals for the NY-series Controller. Read all of the manuals
that are relevant to your system configuration and application before you use the NY-series Controller.
Most operations are performed from the Sysmac Studio Automation Software. Refer to the Sysmac
Studio Version 1 Operation Manual (Cat. No. W504) for information on the Sysmac Studio.
Manual
Basic information
Purpose of use
NY-series IPC Machine Controller Industrial Panel PC Hardware User's Manual NY-series IPC Machine Controller Industrial Box PC Hardware User's Manual NY-series IPC Machine Controller Industrial Panel PC / Industrial Box PC Setup User's Manual NY-series IPC Machine Controller Industrial Panel PC / Industrial Box PC Software User
’s Manual
NY-series Instructions Reference Manual NY-series IPC Machine Controller Industrial Panel PC / Industrial Box PC Motion Control User's Manual NY-series Motion Control Instructions Reference Manual NY-series IPC Machine Controller Industrial Panel PC / Industrial Box PC Built-in EtherCA
T Port User’s Manual
NY-series IPC Machine Controller Industrial Panel PC / Industrial Box PC Built-in EtherNet/IP Port User's Manual NJ/NY-series NC Integrated Controller User's Manual NY-series T
roubleshooting Manual
Introduction to NY-series Pan-
el PCs
¡
Introduction to NY-series Box
PCs
¡
Setting devices and hardware
¡ ¡
Using motion control
¡
Using EtherCAT
¡
Using EtherNet/IP
¡
Making setup
*1
¡
Making the initial set-
tings
Preparing to use Con-
trollers
Software settings
¡
Using motion control
¡
Using EtherCAT
¡
Using EtherNet/IP
¡
Using numerical con-
trol
¡
Writing the user program
¡ ¡
Using motion control
¡ ¡
Using EtherCAT
¡
Using EtherNet/IP
¡
Using numerical con-
trol
¡
Programming error
processing
¡
Relevant Manuals
2
NY-series Motion Control Instructions Reference Manual (W561)