Troubleshooting
15-24
Synchronous parameter: Electronic cam related errors
●: Recoverable, -: Unrecoverable
Error name Description Object
Recovered
Countermeasures
5300H
Electronic cam -
Cam control
synchronous master
axis cycle setting
error
The setting for the cam control
synchronous master axis cycle
is incorrect.
Each
axis
Check the set value.
If the error occurs repeatedly
with the correct set values,
please contact us.
5301H
Electronic cam -
Used cam pattern
no. setting error
The used cam pattern number
is out of the range.
The used cam pattern number
is not registered.
Each
axis
5302H
Electronic cam -
Cam stroke amount
setting error
The setting for the cam stroke
amount is incorrect.
Each
axis
5310H
Advance angle
correction function /
Reference amount
setting error
The advance angle correction
reference amount setting is
incorrect.
Each
axis
5311H
Advance angle
correction function /
Reference speed
setting
The advance angle correction
reference speed setting is
incorrect.
Each
axis
5312H
Advance angle
correction function /
Parameter change
time error
Advance angle correction
parameter change time setting
is incorrect
Each
axis
(Note): To simplify the displays, only the lower four digits (Hex) of each error code are displayed in the above table.
To Next Page
Loading...
