Panasonic AFP7MC16EC - Page 426

Specifications
16-30
●: Available, -: Not available
Axis no.
Unit
memory
no. (Hex)
Name Default Description R W
1-16 UM 001CE
Warning
clear request
H0
Requests the warning clear for FP7 MC Unit.
Clears warnings and warning logs by turning
on this request.
 
17-32 UM 001CF
33-48 UM 001D0
49-64 UM 001D1
Virtual 1-16 UM 001D2
Virtual 17-32 UM 001D3
1-16 UM 001D4
Synchronous
setting
request
H0
This contact turns on after changing the
parameter setting of synchronous operation.
 
17-32 UM 001D5
33-48 UM 001D6
49-64 UM 001D7
-
UM 001D8
-UM 001D9
Reserved for
system
- - - -
1-16 UM 001DA
Synchronous
cancel
request
H0
Turns on the request for the amplifier to cancel
the synchronous operation.
This request signal is enabled when the bits
corresponding to each axis number are on.
(The operation is the level type.)
 
17-32 UM 001DB
33-48 UM 001DC
49-64 UM 001DD
-
UM 001DE
-UM 001DF
Reserved for
system
- - - -
1-16 UM 001E0
Slave axis
gear ratio
change
request
H0
Changes the gear ratio when the request flag
for the corresponding axis during the
synchronous operation turns on. (The
operation is the edge type.)
This request signal is enabled when the bits
corresponding to each axis number turn on.
(The operation is the edge type.)
 
17-32 UM 001E1
33-48 UM 001E2
49-64 UM 001E3
-
UM 001E4
-UM 001E5
Reserved for
system
- - - -
1-16 UM 001E6
Slave axis
clutch ON
request
H0
Starts the clutch on operation when the
request flag for the corresponding axis during
the synchronous operation turns on.
* Amplifiers that no clutch is used do not
operate.
(Set the operation to level type, leading edge,
or trailing edge.)
 
17-32 UM 001E7
33-48 UM 001E8
49-64 UM 001E9
-
UM 001EA
-UM 001EB
Reserved for
system
- - - -
(Note 1): Request flags for 16 axes are allocated to each area (1 word).
bit no.
15
0
8 7
9 1816
● ● ● ● ● ●● ● ● ● ● ●
Axis no.
25 172432
●
●
● ● ● ●● ● ● ●
●
●
41 334048
● ● ● ● ● ●● ● ● ● ● ●
57 495664
● ● ● ● ● ●● ● ● ● ● ●