Operating the Drive 4-9
DC590+ Series DC Digital Drive
Microtach and Encoder Feedback Option Boards
WARNING!
Do not fit this Option Board with the drive powered-up.
IMPORTANT
The Microtach Option Board is fitted with an 11 pin connector. Fit this as shown in the diagram below.
The board plugs into the front of the drive. Mount it on the 10-pin connector correctly. This will allow the
locating pegs to align with the mounting holes.
These option boards assume a 1000 lines per rev encoder is being used. Speed is set directly by the
ENCODER RPM parameter. If you are using an alternative lines per rev encoder, you must set the ENCODER
LINES parameter on the Keypad later in the Operating Instructions.
Save Your Settings
CONFIGURE ENABLE
Set to FALSE.
PARAMETER SAVE
Perform a Parameter Save to save your settings. Press the ▲ (UP) key,
as instructed.
unused connector
MMI Menu Ma
To Next Page
Loading...
