Parker 590+ series - Wiring Requirements for EMC Compliance

E-28 Technical Specifications
DC590+ Series DC Digital Drive
Terminal Information – Option Boards
Terminal Description Terminal Function Signal Level Terminal Number
(5901 MICROTACH OPTION MODULE - GLASS)
Signal Input Microtach fibre optic
input
There are no other connections to this option module. (The 5901 Microtach should be
powered by an external 24V DC at 125mA, 3W.)
F1
TERMINAL BLOCK G (ENCODER OPTION)
Terminal Block G pinouts will change function depending upon which option board is fitted to the control board. The configuration supplied as standard is with
the Switchable Tacho Calibration Option fitted. Further information on the other options may be obtained from the relevant Technical Manual.
TECHNOLOGY BOX OPTION (SERIAL COMMUNICATIONS)
Refer to the Technical Manual supplied with the option for details.
Wiring Requirements for EMC Compliance
Where shielded/armoured cables are specified, use "SY" or "CY" type cables for better performance.
Power Supply Wire Motor Wire External Filter to Drive Wire Signal/Control Wire
Wire Type
(for EMC Compliance)
Unshielded Shielded/
armoured
Replace flying leads with shielded/armoured when >0.6m Shielded
Segregation From all other wiring
(clean)
From all other wiring (noisy) From all other wiring
(sensitive)
Length Limitations
With External Filter
Unlimited 50 metres As short as possible 25 metres
Shield to Ground
Connection
Both ends Both ends Drive end only