Installing the Drive 3-5
DC590+ Series DC Digital Drive
Mounting the Drive
NOTE General installation details are given below for mounting the Drive, however, if you are installing the unit with an
EMC filter refer to “30HExternal AC Supply EMC Filter Installation, page 31H3-60.
Mount the unit vertically on a solid, flat, vertical surface. It is mounted using bolts or screws into four fixing points (keyhole slots). The design allows
the use of 100mm grid fixing.
It must be mounted inside a suitable cubicle. To comply with the European safety standards VDE 0160 (1994)/EN50178 (1998), the cubicle must
require a tool for opening.
NOTE Holes for the mounting bolts or screws must be placed accurately.
Cover any units all ready mounted to the panel to protect them from stray metal filings while drilling mounting holes.
General Mounting Hints
Caution
Use proper lifting techniques when lifting and moving.
Drill the mounting holes into the backplate. The holes must be positioned accurately. Fit the nut inserts. Fit bolts and washers into the top inserts so
that the drive can be hung using the keyhole slots.
Hang the drive on the bolts, between the panel and washers you have just fitted. Fit bolts and washers to the lower nut inserts. Finally, use the socket
wrench to tighten all nuts securely.
Check the drive and its housing for packing material, mounting debris, or any other material that could damage and/or restrict the operation of the
equipment.
Recommended Tools
Socket wrench With a 6 Inch extension
Deep sockets M6, M10, M13, M17, 7/16”, 1/2”
Screwdrivers Phillips No.2, flat blade - 0.5 x 3.0mm, 0.8 x 4.0mm
Wire cutters Small
To Next Page
Loading...
