Parker 590+ series - Control Key Definitions; Keys for Programming the Drive

6-2 The Keypad
DC590+ Series DC Digital Drive
Control Key Definitions
Keys for Programming the Drive
NOTE Refer to “Navigating the Menu System”, page 6-7 for a quick-start to using the menu.
UP
Navigation - Moves upwards through the list of parameters.
Parameter - Increments the value of the displayed parameter.
Command Acknowledge - Confirms action when in a command menu.
DOWN Navigatio n - Moves downwards through the list of parameters.
Parameter - Decrements the value of the displayed parameter.
ESCAPE Navigation - Displays the previous level’s Menu.
Parameter - Returns to the parameter list.
Trip Acknowledge - Acknowledges displayed Trip or Error message.
MENU Navigation - Displays the next Menu level, or the first parameter of the current Menu.
Parameter - Holding M down when a parameter is displayed shows that parameter’s Tag No. Repeated pressing at
a writable parameter moves a cursor across the value to allow rapid increment/decrement of the parameter value.
PROG Navigation - When in Local mode, displays the previous MMI menu whilst remaining in Local mode enabling
changes to be made to parameters not available in Local menu. The key has no function in Remote mode.
LOCAL/
REMOTE
Control - Toggles between Remote and Local Control Modes for both Start/Stop (Seq) and Speed Control (Ref).
When toggling, the display automatically goes to the relevant SETPOINT screen, and the SETPOINT (LOCAL) screen
will have the
and keys enabled to alter the setpoint.