Parker 590+ series - Emulating Earlier Software Versions

Programming D-11
DC590+ Series DC Digital Drive
Emulating Earlier Software Versions
Software V8.x introduces the EMULATE 590P parameter (Configure Drive function block). When non-zero, this parameter
forces the drive to emulate some behaviour of earlier software versions of the 590P, (firmware versions 5.x and 7.x).
Refer to the “EMULATE 590P” parameter (tag 162), page D-34.
This behaviour affects:
Refer to:
the time constants of the PID block
Execution Rules D-2, PID function block D-89.
a number of parameters in the FIELD CONTROL block
FIELD CONTROL function block D-63
the linking of parameters in the function block diagram (discussed earlier in this section)
the speed loop EMULATE 590P” parameter (tag 162), page D-34.