Parker 590+ series - Serial Links; System; Software Parameter; Configure I;O Paramater

6-18 The Keypad
DC590+ Series DC Digital Drive
SERIAL LINKS
This menu contains 3 function blocks. These can be found in the SETUP PARAMETERS menu - refer to Appendix D: "Programming".
SERIAL LINKS
•_ TEC OPTION refer to Appendix D:"Programming"
•_ SYSTEM PORT (P3) refer to Appendix D:"Programming"
•_ PNO CONFIG refer to Appendix D:"Programming"
SYSTEM
This menu contains 2 parameters and 3 function blocks. The function blocks can be found in the SETUP PARAMETERS menu - refer to Appendix D:
"Programming".
SYSTEM
•_ SOFTWARE see below
•_ CONFIGURE I/O see below
•_ miniLINK refer to Appendix D:"Programming" - miniLINK
•_ SAVE TO OP refer to Appendix D:"Programming" - CONFIGURE DRIVE
•_ LOAD FROM OP refer to Appendix D:"Programming" - CONFIGURE DRIVE
SOFTWARE Parameter
This parameter displays the software release of the firmware in the drive.
CONFIGURE I/O Parameter
This parameter is repeated in several menus. It is used whenever you want to save any changes that are made to a parameter.
Refer to Appendix D: "Programming" - Modifying a Block Diagram.
PARAMETER SAVE
Refer to "Saving Your Application", page 6-23.