Parker 590+ series User Manual

Serial Communications A-9
DC590+ Series DC Digital Drive
EI Bisynch ASCII Parameter Mapping
1. EI Bisynch ASCII Prime Set
The following prime set parameters are supported:
Mnemonic Description Range (HEX encoding) Access
II Instrument Identity >0690, >0605 or >5900 Read Only
V0 Main Software Version >0000 to >FFFF Read Only
V1 Keypad
Software Version
>0000 to >FFFF
(>0000 if not fitted)
Read Only
V2 Technology Box Software Version >0000 to >FFFF Read Only
EE Last Error Code >0000 to >FFFF
(Writing any value resets this to >00C0)
Read/Write
2. Command/Status
The following Command/Status parameters are supported:
Mnemonic Description Range (Hex encoding) Access
!1 Command see below Write Only
!2 State see below Read Only
!3 Save Command see below Write Only
!4 Save State see below Read Only

Parker 590+ series Specifications

General

Control Mode	Speed, Torque, Position
Operating Temperature	0°C to 40°C
Altitude	Up to 1000 m without derating
Speed Regulation	0.01% of base speed
Communication Options	Ethernet, Profibus, CANbus, Modbus, DeviceNet
Feedback Options	Tachometer, Encoder
Protection Rating	IP20
Storage Temperature	-25°C to 55°C
Relative Humidity	5% to 95% (non-condensing)