D-32 Programming
DC590+ Series DC Digital Drive
COMMS PORT
Use this block to configure the drive's P3 port.
Refer to Appendix A: “Serial Communications” - System Port P3 for further information.
The P3 port is a non-isolated serial communications port built in to the drive's Control Board.
It is used off-line (while the drive is stopped) for transferring and saving drive configuration
files using a personal computer (PC) running a serial communications program, or on-line
(while the drive is running) when using the Parker SSD Drives 5703 Setpoint Repeater Unit.
You can also use the P3 port to transfer configuration files by connecting to a PC running the
Windows
TM
compatible software package "DSELite". Refer to the DSELite manual
HA471486.
COMMS PORT
MODE 130 See below
Used the set the protocol on this port.
0 : DISABLED
1 : 5703 MASTER
2 : 5703 SLAVE
3 : EIASCII
4 : EIBINARY
BAUD RATE 198 See below
Transmission rate. Options available are:
0 : 300
1 : 600
2 : 1200
3 : 2400
4 : 4800
5 : 9600 (default)
6 : 19200
7 : 38400
8 : 57600
9 : 115200
GROUP ID (GID) 329 0 to 7
The Parker SSD Drives protocol group identity address.
To Next Page
Loading...
