Certification B-15
DC590+ Series DC Digital Drive
Certificates
590P
EC DECLARATIONS OF CONFORMITY
Date CE marked first applied: 01.04.2001
EMC Directive
Low Voltage Directive
Issued for compliance
with the EMC Directive
when the unit is used as
relevant apparatus.
In accordance with the EEC Directive
2004/108/EC
We Parker SSD Drives, address as below, declare under our
sole responsibility that the above Electronic Products when
installed and operated with reference to the instructions in the
Product Manual (provided with each piece of equipment) is in
accordance with the relevant clauses from the following
standard:-
* BSEN61800-3 (2004)
In accordance with the EEC Directive
2006/95/EC
We Parker SSD Drives, address as below, declare under our
sole responsibility that the above Electronic Products when
installed and operated with reference to the instructions in the
Product Manual
(provided with each piece of equipment), is in accordance with
the relevant clauses from the following standard :-
EN50178 (1998)
The drive is CE marked in
accordance with the low voltage
directive for electrical
equipment and appliances in the
voltage range when installed
correctly.
MANUFACTURERS DECLARATIONS
EMC Declaration
Machinery Directive
This is provided to aid
your justification for
EMC compliance when
the unit is used as a
component.
We Parker SSD Drives, address as below, declare under our
sole responsibility that the above Electronic Products when
installed and operated with reference to the instructions in the
Product Manual (provided with each piece of equipment) is in
accordance with the relevant clauses from the following
standard:-
* BSEN61800-3 (2004)
The above Electronic Products
are components to be incorporated into machinery
and may not be operated alone.
The complete machinery or installation using this equipment
may only be put into service when the safety considerations of
the Directive 2006/42/EC are fully adhered to.
Particular reference should be made to EN60204-1 (Safety of
Machinery - Electrical Equipment of Machines).
All instructions, warnings and safety information of the
Product Manual must be adhered to.
Since the potential hazards are
mainly electrical rather than
mechanical, the drive does not
fall under the machinery
directive. However, we do
supply a manufacturer's
declaration for when the drive is
used (as a component) in
machinery.
Dr Martin Payn (Conformance Officer)
Compliant with the immunity requirements of the Standard without specified EMC filters.
PARKER HANNIFIN MANUFACTURING LTD., AUTOMATION GROUP, SSD DRIVES EUROPE,
NEW COURTWICK LANE, LITTLEHAMPTON, WEST SUSSEX BN17 7RZ
TELEPHONE: +44(0)1903 737000 FAX: +44(0)1903 737100
Registered Number: 4806503 England. Registered Office: 55 Maylands Avenue, Hemel Hempstead, Herts HP2 4SJ
To Next Page
Loading...
