Parameter Specification Tables C-37
DC590+ Series DC Digital Drive
a.......ANOUT 1 (A7) [0055] Analog Output
a.......ANOUT 2 (A8) [0056] Analog Output
a.......START (C3) [0068] Sequencing
a.......DIGITAL INPUT C4 [0069] Digital Input
a.......DIGITAL INPUT C5 [0070] Digital Input
a.......DIGIN 1 (C6) [0071] Digital Input
a.......DIGIN 2 (C7) [0072] Digital Input
a.......DIGIN 3 (C8) [0073] Digital Input
a.......DIGOUT 1 (B5) [0074] Digital Output
a.......DIGOUT 2 (B6) [0075] Digital Output
a.......DIGOUT 3 (B7) [0076] Digital Output
........RAISE/LOWER O/P [0264] Raise/Lower
a.......PID OUTPUT [0417] PID
a.......PID CLAMPED [0416] PID
a.......PID ERROR [0415] PID
a.......SPT SUM OUTPUT [0086] Setpoint Sum
a.......RAMP OUTPUT [0085] Ramps
........PRESET O/P [0572] Preset Speeds
........SRAMP OUTPUT [0589] Sramp
........OUTPUT FPM [0593] Preset Speeds
........SPEED SETPOINT [0063] Speed Loop
a.......TERMINAL VOLTS [0057] Calibration
........BACK EMF [0060] Calibration
........ARM VOLTS FBK [0605] Feedbacks
........TACH INPUT [0308] Feedbacks
........UNFIL.TACH INPUT [0058] Calibration
........ENCODER [0206] Encoder
........UNFIL.ENCODER [0059] Encoder
........UNFIL.SPD.FBK [0062] Speed Loop
........UNFIL.SPD.ERROR [0064] Speed Loop
........CONTACTOR CLOSED [0083] Sequencing
........HEALTH LED [0122] Alarms
........READY [0125] Sequencing
........DRIVE RUNNING [0376] Sequencing
........SYSTEM RESET [0374] Sequencing
......SETUP PARAMETERS
........RAMPS
..........RAMP ACCEL TIME [0002] Ramps
..........RAMP DECEL TIME [0003] Ramps
a.........RAMP HOLD [0118] Ramps
To Next Page
Loading...
