Parker 590+ series - Page 333

Parameter Specification Tables C-43
DC590+ Series DC Digital Drive
..........CONFIGURE ENABLE [0039] Configure Drive
..........NOM MOTOR VOLTS [0521] Configure Drive
..........ARMATURE CURRENT [0523] Configure Drive
..........FIELD CURRENT [0524] Configure Drive
..........ARMATURE V CAL. [0020] Calibration
..........IR COMPENSATION [0021] Calibration
..........ENCODER RPM [0022] Encoder
..........ENCODER LINES [0024] Encoder
..........ANALOG TACH CAL [0023] Calibration
..........ZERO SPD. OFFSET [0010] Calibration
..........ARMATURE I (A9) [0025] Calibration
a.........SPDFBK ALM LEVEL [0180] Alarms
a.........STALL THRESHOLD [0263] Alarms
a.........STALL TRIP DELAY [0224] Alarms
..........REM TRIP DELAY [0541] Alarms
..........FIELD I CAL. [0182] Calibration
........INHIBIT ALARMS
..........FIELD FAIL [0019] Alarms
..........5703 RCV ERROR [0111] Alarms
a.........STALL TRIP [0028] Alarms
a.........TRIP RESET [0305] Alarms
..........SPEED FBK ALARM [0081] Alarms
..........ENCODER ALARM [0092] Alarms
..........REM TRIP INHIBIT [0540] Alarms
........CURRENT LOOP
..........MAIN CURR. LIMIT [0421] Current Loop
..........PROP. GAIN [0016] Current Loop
..........INT. GAIN [0017] Current Loop
..........AUTOTUNE [0018] Auto-Tune
..........DISCONTINUOUS [0137] Current Loop
a.........ADDITIONAL DEM [0030] Current Loop
a.........BIPOLAR CLAMPS [0090] Current Loop
..........REGEN ENABLE [0201] Current Loop
..........MASTER BRIDGE [0527] Current Loop
..........POS. I CLAMP IN [0301] Current Loop
a.........NEG. I CLAMP IN [0048] Current Loop
a.........I DMD. ISOLATE [0119] Current Loop
..........CUR.LIMIT/SCALER [0015] Current Loop
........SPEED LOOP
..........SPD.PROP.GAIN [0014] Speed Loop