Parker 590+ series - Page 383

Programming D-39
DC590+ Series DC Digital Drive
Functional Description
Note 1: I DMD. ISOLATE removes speed loop
demand and selects analog I/P 2 as
current regulator demand.
I DMD. ISOLATE is overridden by
program stop and stop to return drive to
speed regulation.
Note 2: REGEN ENABLE = 2Q (NON-REGEN)
prevents negative current demand. Non-
regenerative drives use non-regen mode
irrespective of the REGEN ENABLE
parameter setting.
(filtered)
(filtered)
DIGITAL I/P 3