Parker AC30 series - PTP Parameter Summary

Ethernet 8-25
AC30 series Variable Speed Inverters
PTP Parameter Summary
Note: The value of the PTP configuration parameters only become active when the PTP module initialises, i.e. on inverter power-up, on transition
of the parameter 1661 PTP Enable to TRUE or connection of one or more Ethernet cables.
Parameter Name No. Path Default Range Units Writable
PTP Enable
166
1
Setup::Communications::PTP
Parameters::Base
Comms::PTP
FALSE
FALSE
TRUE
ALWAY
S
PTP parameter.
Enables the precision time protocol.
PTP Clock Type
168
4
Setup::Communications::PTP
Parameters::Base
Comms::PTP
0: MASTER OR
SLAVE
0:MASTER OR
SLAVE
1:SLAVE ONLY
ALWAY
S
PTP parameter
Sets if the inverter can become a master or slave clock, or a slave clock only.
Enumerated values:
0: MASTER OR SLAVE
- the device clock will become a Master if it is determined to be the best
master in a network, otherwise it will become a Slave
1: SLAVE ONLY
- the device clock can only become a Slave
PTP Clock Mode
168
3
Setup::Communications::PTP
Parameters::Base
Comms::PTP
0:E2E
0:E2E
ALWAY
S
PTP parameter.
Sets the PTP clock mode to either end-to-end (E2E) or peer-to-peer (P2P). See description in section
Advanced Users for more details. Note that currently E2E is only available.
Enumerated values:
0: E2E