Parker AC30 series - Trips and Auto Restart

9-4 Fire Mode
AC30 series Variable Speed Drive
Trips and Auto Restart
The following table summarizes which trips are disabled in the two modes of operation. Also shown are those trips which are designed to protect
the drive.
ID
Trip Name
Disabled in Partial mode
Disabled in Full mode
Drive Protection
1
OVER VOLTAGE

2
UNDER VOLTAGE
(1)
Note 1
Note 1
3
OVER CURRENT

4
STACK FAULT

5
STACK OVER CURRENT

6
CURRENT LIMIT
 
7
MOTOR STALL
 
8
INVERSE TIME
 
9
MOTOR I2T
 
10
LOW SPEED I
 
11
HEATSINK OVERTEMP
 
12
AMBIENT OVERTEMP
 
13
MOTOR OVERTEMP
 
14
EXTERNAL TRIP
 
15
BRAKE SHORT CCT
 
16
BRAKE RESISTOR
 
17
BRAKE SWITCH
 
18
LOCAL CONTROL
 
19
COMMS BREAK
 
20
LINE CONTACTOR
 
21
PHASE FAIL
 
22
VDC RIPPLE
 
23
BASE MODBUS BREAK
 
24
24V OVERLOAD
 
25
PMAC SPEED ERROR
 
Caution Disabling the Drive Protection trips will invalidate the drive’s warranty. Selecting PARTIAL mode leaves the drive protection features
enabled. Selecting FULL mode disables some of the drive protection features.
Caution Regardless of the setting of Level, activating Fire Mode may cause damage to the motor or attached equipment.