Parker AC30 series User Manual

C-188 Parameter Reference
AC30 series Variable Speed Drive
SD Card
Parameters::Device Manager::SD Card
Details of the SD Card fitted in the Drive.
Parameter Name
No.
Path
Default
Range
Units
Writable
Card State
1033
Parameters::Device Manager::SD Card
0:NO CARD
1:INITIALISING
2:READY
3:CARD FAULT
NEVER
The state of the SD Card will either be:
0: NO CARD no card detected in slot
1: INITIALISING a card has been detected but is still preparing for use
2: READY the card inserted can be used
3: CARD FAULT the card inserted is faulty and cannot be used. Check “Extended Support” below.
Card Name
1034
Parameters::Device Manager::SD Card
NEVER
The Volume Label read from the card. This is normally entered when formatting the card. It may be left blank.
Firmware
1038
Parameters::Device Manager::SD Card
NEVER
TRUE indicates that the firmware upgrade file (firmware.30x) is present on the inserted SD Card.
Application Archive
1039
Parameters::Device Manager::SD Card
NEVER
TRUE indicates that the project archive file (archive.prj) is present on the inserted SD Card and that the contents of this file matches
the loaded Project.
FALSE indicates that either the project archive file is not on the SD Card or that the archive file does not contain the archive of the
loaded Project.
Extended Support
0117
Parameters::Device Manager::SD Card
TRUE
ALWAYS
Set TRUE to support a wider range of SD Cards. This parameter is ignored if Precision Time Protocol, (PTP), is enabled.

Parker AC30 series Specifications

General

Control Modes	Closed-loop vector
Feedback	Encoder
Operating Temperature	0 to 40°C (32 to 104°F) standard, -20 to 50°C (-4 to 122°F) with derating
Protection	Overcurrent, Overvoltage, Undervoltage
Communication	RS485