Parker AC30 series User Manual

8-30 Ethernet
AC30 series Variable Speed Inverters
Peer to Peer
The Peer to Peer module is implemented in the AC30P and AC30D inverters and provides Ethernet communications between inverters.
The data sent is not accessible to the user. The initial use of the Peer to Peer module is for shaft locking applications using the Virtual Master or
Real Master control and used in conjunction with the Precision Time Protocol (PTP).
Note: The Peer to Peer module broadcasts data at a high rate, as such, when the Peer to Peer module is enabled it is recommended not to
connect the inverters to a corporate or other sensitive network.
Configuration
To enable the Peer to Peer module set the parameter 1725 Peer to Peer Enable to TRUE on all inverters participating. For most applications
the default settings may be used. For further configuration of the module see the section Peer to Peer Parameter Summary.

Parker AC30 series Specifications

General

Control Modes	Closed-loop vector
Feedback	Encoder
Operating Temperature	0 to 40°C (32 to 104°F) standard, -20 to 50°C (-4 to 122°F) with derating
Protection	Overcurrent, Overvoltage, Undervoltage
Communication	RS485