Parker AC30 series - System Board Option

C-216 Parameter Reference
AC30 series Variable Speed Drive
System Board Option
Parameters::System Board::System Board Option
Parameter Name
No.
Path
Default
Range
Units
Writable
System Board Required
1739
Setup::Inputs and Outputs::System Board
Option
Parameters::System Board::System Board
Option
0:NONE
1:DUAL ENCODER
2:ABSOLUTE
CONFIG
Identifies whether the system board is required by the configuration.
System Board Fitted
1740
Parameters::System Board::System
Board Option
Same as PNO 1739
NEVER
Indicates whether the system board is attached. The system board is a factory fit option.
System Board Status
1741
Parameters::System Board::System
Board Option
0:OK
1:OPTION NOT FITTED
2:TYPE MISMATCH
3:TYPE UNKNOWN
4:HARDWARE FAULT
NEVER
Indicates the health of the system board, if attached.
Functional Description
These parameters are used to set and verify the System Board Option configuration. If the status parameter is not OK then the drive will not enter
the Operational state.
Status
Description
OK
The configuration is valid. The status will always be OK if no System Board option is required, even if one is fitted.
OPTION NOT FITTED
An option was required and none was detected
TYPE MISMATCH
The fitted option does not support the required features
TYPE UNKNOWN
The firmware in the drive does not recognise the fitted option
HARDWARE FAULT
The fitted option is not working as expected.