8-14 Ethernet
AC30 series Variable Speed Inverters
Changing the Ethernet settings on the PC
Normally the PC Ethernet adapter is set to obtain an IP address automatically either from a DHCP server or using an automatic private IP
address (Auto-IP). The adapter settings may be checked / modified as follows:
For Windows XP under Control Panel Network Connections
For Windows 7 under Control Panel Network And Sharing Center Change adapter settings
Right-click on the required network adapter and choose Properties, then double-click on Internet Protocol (TCP/IP) (Windows XP) or Internet
Protocol Version 4 (TCP/IPv4) (Windows 7).
To use a fixed IP address make sure Use the following Ip address under the General tab is chosen and enter the required IP address, subnet
mask and default gateway.
To use DHCP or Auto-IP make sure Obtain IP address automatically under the General tab is selected and under the Alternate
Configuration tab that Automatic private IP address is selected.
To Next Page
Loading...
