R&S ZNL Series - Page 462

VNA GUI reference
R&S
®
ZNL/ZNLE
462User Manual 1178.5966.02 ─ 20
Note: The marker Evaluation Ranges are identical to the evaluation ranges for trace
statistics. For more information, see Chapter 10.6.8.2, "Evaluation Range dialog",
on page 381.
Remote command:
CALCulate<Chn>:MARKer<Mk>:FUNCtion:DOMain:USER[:RANGe]
CALCulate<Chn>:MARKer<Mk>:REFerence:FUNCtion:DOMain:USER[:RANGe]
CALCulate<Chn>:MARKer<Mk>:FUNCtion:DOMain:USER:STARt
CALCulate<Chn>:MARKer<Mk>:REFerence:FUNCtion:DOMain:USER:STARt
CALCulate<Chn>:MARKer<Mk>:FUNCtion:DOMain:USER:STOP
CALCulate<Chn>:MARKer<Mk>:REFerence:FUNCtion:DOMain:USER:STOP
Range Limit Lines On
Displays or hides the range limit lines in the diagram area. Range limit lines are two
vertical lines at the Start and Stop values of the active search range ("Range 1" to
"Range 10").
Remote command:
CALCulate<Chn>:MARKer<Mk>:FUNCtion:DOMain:USER:SHOW
CALCulate<Chn>:MARKer<Mk>:REFerence:FUNCtion:DOMain:USER:SHOW
10.11.1.3 Marker Config dialog
The "Marker Config" dialog allows you to configure the peak searches for the active
trace and all its markers.
Access:
●
[Mkr->] > "Peak" > "Marker Config..."
●
[Mkr->] > "Multiple Peak" > "Marker Config..."
Marker Search softtool