R&S ZNL Series - Page 588

Command reference
R&S
®
ZNL/ZNLE
588User Manual 1178.5966.02 ─ 20
The file name depends on the one you have set with MMEMory:STORe<1|2>:STATe
on page 587. This command adds a consecutive number to the file name.
Suffix:
<1|2>
.
irrelevant
Example:
MMEM:STOR:STAT 1,'Save'
Saves the current instrument settings in the file Save.dfl.
MMEM:STOR:STAT:NEXT
Saves the current instrument settings in the file Save_001.dfl
MMEM:STOR:STAT:NEXT
Saves the current instrument settings in the file Save_002.dfl
Manual operation: See "Save File" on page 101
MMEMory:STORe<1|2>:TYPE
<Type>
This command defines whether the data from the entire instrument or only from the
current channel setup is stored with the subsequent MMEM:STOR... command.
Suffix:
<1|2>
.
irrelevant
Parameters:
<Type> INSTrument | CHANnel
INSTrument
Stores data from the entire instrument.
CHANnel
Stores data from an individual channel setup.
*RST: INST
Example:
INST:SEL 'SPECTRUM2'
Selects channel setup'SPECTRUM2'.
MMEM:STOR:TYPE CHAN
Specifies that channel setup data is to be stored.
SYSTem:PRESet
This command presets the R&S ZNL/ZNLE. It is identical to *RST.
Example:
SYST:PRES
Usage: Event
SYSTem:PRESet:CHANnel[:EXEC]
This command restores the default instrument settings in the current channel setup.
Use INST:SEL to select the channel setup.
For details see Chapter 6.1, "Restoring the default instrument configuration (preset)",
on page 94.
Common instrument commands