R&S ZNL Series - Page 605

Command reference
R&S
®
ZNL/ZNLE
605User Manual 1178.5966.02 ─ 20
CALibration:DUE:SHUTdown <State>
If activated, the R&S ZNL/ZNLE is automatically shut down after self-alignment is com-
pleted. Note that the instrument cannot be restarted via remote control.
Parameters:
<State> ON | OFF | 0 | 1
OFF | 0
Switches the function off
ON | 1
Switches the function on
*RST: 0
Example: //Schedule a self-alignment every Sunday at 2 AM after a
warmup period, then shut down instrument.
CAL:DUE:WARM
CAL:DUE:SCH ON
CAL:DUE:DAYS SUND
CAL:DUE:TIME '2:00'
CAL:DUE:SHUT
CALibration:DUE:TIME <Time>
Defines the time at which a self-alignment is scheduled for the days specified by
CALibration:DUE:DAYS, if CALibration:DUE:SCHedule ON.
Parameters:
<Time> string with format 'hh:mm' (24 hours)
Example: //Schedule a self-alignment every Sunday at 2 AM after a
warmup period, then shut down instrument.
CAL:DUE:WARM
CAL:DUE:SCH ON
CAL:DUE:DAYS SUND
CAL:DUE:TIME '2:00'
CAL:DUE:SHUT
CALibration:DUE:WARMup <State>
If enabled, self-alignment is started automatically after the warmup operation has com-
pleted.
Parameters:
<State> ON | OFF | 0 | 1
OFF | 0
Switches the function off
ON | 1
Switches the function on
*RST: 0
Common instrument commands