R&S ZNL Series - Page 661

Command reference
R&S
®
ZNL/ZNLE
661User Manual 1178.5966.02 ─ 20
Example:
*RST; :CALC:FILT:TIME:SHAP?
Reset the instrument and query the type of time gate used. The
response is WIDE.
Manual operation: See "Shape" on page 367
CALCulate<Chn>:FILTer[:GATE]:TIME:SHOW <Boolean>
Enables or disables permanent display of the gate limits.
Suffix:
<Chn>
.
Channel number used to identify the active trace
Parameters:
<Boolean> ON - time gate permanently displayed
OFF - time gate hidden
*RST: OFF
Example: See CALCulate<Chn>:FILTer[:GATE]:TIME:CENTer
Manual operation: See "Show Range Lines" on page 366
CALCulate<Chn>:FILTer[:GATE]:TIME:SPAN <Span>
Defines the span of the time gate.
Suffix:
<Chn>
.
Channel number used to identify the active trace
Parameters:
<Span> Span of the time gate.
Range: 2E-012 s to 200 s
Increment: 0.1 ns
*RST: 5E-009 s
Default unit: s
Example: See CALCulate<Chn>:FILTer[:GATE]:TIME:CENTer
Manual operation: See "Axis Pair" on page 366
CALCulate<Chn>:FILTer[:GATE]:TIME:STARt <StartTime>
CALCulate<Chn>:FILTer[:GATE]:TIME:STOP <StopTime>
These commands define the start and stop times of the time gate, respectively.
Suffix:
<Chn>
.
Channel number used to identify the active trace
VNA command reference