R&S ZNL Series - Page 665

Command reference
R&S
®
ZNL/ZNLE
665User Manual 1178.5966.02 ─ 20
Suffix:
<Chn>
.
Channel number used to identify the active trace
Parameters:
<CenterX> Range: Virtually no restriction for center coordinates.
*RST: 0
Default unit: NN
<CenterY> Range: Virtually no restriction for center coordinates.
*RST: 0
Default unit: NN
<Radius> Range: Virtually no restriction for radius (use positive val-
ues).
*RST: 1
Default unit: NN
Example: See CALCulate<Chn>:LIMit:CIRCle[:STATe]
Manual operation: See "Radius / Center X / Center Y" on page 447
CALCulate<Chn>:LIMit:CIRCle:DISPlay[:STATe] <Boolean>
Displays or hides the circle limit line associated to the active trace.
Suffix:
<Chn>
.
Channel number used to identify the active trace
Parameters:
<Boolean> ON | OFF - Circle limit line on or off.
*RST: OFF
Example:
*RST; CALCulate:LIMit:CIRCle:DATA 0, 0, 0.5
Define a circle limit line centered around the origin of the polar
diagram, assigning a radius of 0.5 U.
CALCulate:FORMat POLar
CALCulate:LIMit:CIRCle:DISPlay ON
Activate a polar diagram and show the circle limit line in the dia-
gram.
Manual operation: See "Show Limit Circle" on page 445
CALCulate<Chn>:LIMit:CIRCle:FAIL?
Returns a 0 or 1 to indicate whether or not the circle limit check has failed. 0 repre-
sents pass and 1 represents fail
Tip: Use CALCulate:CLIMits:FAIL? to perform a composite (global) limit check.
Suffix:
<Chn>
.
Channel number used to identify the active trace
Example: See CALCulate<Chn>:LIMit:CIRCle[:STATe]
Usage: Query only
VNA command reference