R&S ZNL Series User Manual

Command reference
R&S
®
ZNL/ZNLE
848User Manual 1178.5966.02 ─ 20
MMEMory:LOAD:CKIT:SDATa:WLABel <ConnectorType>, <CalKitName>,
<KitLabel>, <StandardType>, <StandardLabel>, <TouchstoneFile>[,
<FirstPort>[, <SecondPort>]]
Loads characterization data from the given Touchstone file; similar to existing com-
mand MMEMory:LOAD:CKIT:SDATa but supports cal kit addressing by label.
Setting parameters:
<ConnectorType> String parameter containing the name of the connector type.
<CalKitName> String parameter containing the name of a calibration kit availa-
ble on the analyzer.
<KitLabel> String parameter containing the label of a calibration kit available
on the analyzer. An empty string means that no label is defined.
<StandardType> MMTHrough | MFTHrough | FFTHrough | MMLine | MMLine1 |
MMLine2 | MMLine3 | MFLine | MFLine1 | MFLine2 | MFLine3 |
FFLine | FFLine1 | FFLine2 | FFLine3 | MMATten | MFATten |
FFATten | MMSNetwork | MFSNetwork | FFSNetwork | MOPen |
FOPen | MSHort | FSHort | MOSHort | MOSHort1 | MOSHort2 |
MOSHort3 | FOSHort | FOSHort1 | FOSHort2 | FOSHort3 |
MREFlect | FREFlect | MMTCh | FMTCh | MSMatch | FSMatch
Standard types; for a description refer to table Standard types
and their parameters.
<StandardLabel> String parameter addressing a particular calibration standard by
its label. An empty string means that no label is defined.
<TouchstoneFile> String parameter to specify the name and directory of the Touch-
stone file to be loaded. A *.s1p file must be used for one-port
standards, a *.s2p file for two-port standards.
If no path is specified the analyzer searches the current direc-
tory, to be queried with MMEMory:CDIRectory?
<FirstPort> First port number (sufficient for one-port standards). If the port
numbers are omitted, the cal kit data is valid for all ports.
<SecondPort> Second port number, for two-port standards. If the port numbers
are omitted, the cal kit data is valid for all ports.
Example:
MMEM:LOAD:CKIT:SDAT:WLAB 'N 50 Ohm','Default
Kit','0815',MOPEN,'Test data','test.s1p',1
Load the file Test.s1p from the current directory in order to
define the properties of an Open (m) standard in the cal kit
"Default Kit" with label "0815" for the N 50 Ω connector type.
Assign the label "Test data" and specify that the standard data is
valid for port no. 1 only.
Usage: Setting only
Connector and cal kit naming conventions:
VNA command reference

R&S ZNL Series Specifications

General

Brand	R&S
Model	ZNL Series
Category	Measuring Instruments
Language	English