R&S ZNL Series - Page 856

Command reference
R&S
®
ZNL/ZNLE
856User Manual 1178.5966.02 ─ 20
Example: Assume that the current channel setup contains two channels
numbered 1 and 2, respectively, and that sweep segments have
been defined for channel no. 1.
MMEM:STOR:SEGM 1, 'C:\Users\Public\Documents\
Rohde-Schwarz\ZNL\SweepSegments\Seg_Ch1.SegList'
Store the sweep segment definition of channel 1 to a sweep
segment file.
MMEM:LOAD:SEGM 2, 'C:\Users\Public\Documents\
Rohde-Schwarz\ZNL\SweepSegments\Seg_Ch1.SegList'
Load the previously created sweep segment file and use the
sweep segments for channel 2.
Usage: Setting only
Manual operation: See "Import.../ Export..." on page 336
MMEMory:LOAD:TRACe
<DestinationTraceName>, <TraceFile>[,
<SParamOrTraceName>]
Loads trace data from a specified trace file and assigns it to a trace with a specified
name. Traces are created using the CALCulate<Ch>:PARameter:SDEFine com-
mand.
Setting parameters:
<Destination
TraceName>
Name of an existing data trace in the active channel setup
(string parameter). The trace data is loaded into a memory trace
associated with the specified data trace. If one or more memory
traces are already associated with the specified data trace, the
last generated memory trace is overwritten.
<TraceFile> String parameter to specify the name and directory of the trace
file to be loaded. Several file formats for trace files are suppor-
ted. The file extensions *.s<n>p, *.csv, and *.dat for Touch-
stone, ASCII, and Matlab files are mandatory.
If no path is specified the analyzer searches the current direc-
tory, to be queried with MMEMory:CDIRectory?
<SParam
OrTraceName>
Optional string parameter: For imported Touchstone files for
more than one port (*.s2p, *.s3p, *.s4p), the parameter
denotes the imported S-parameter ('S11', 'S12', ...). For ASCII
(*.csv) and Matlab (*dat) files, the parameter references a
trace name in the file (case sensitive). If the parameter is omit-
ted, the first trace in the specified file is imported.
VNA command reference