Command reference
R&S
®
ZNL/ZNLE
868User Manual 1178.5966.02 ─ 20
If the second optional parameter is omitted, the command stores
complex data.
<DecSeparator> POINt | COMMa
POINt - decimal separator: point.
COMMa - decimal separator: comma.
If the third optional parameter is omitted, points are used.
<FieldSeparator> SEMicolon | COMMa | TABulator | SPACe
SEMicolon - field separator: semicolon
COMMa - field separator: comma.
TABulator - field separator: tabulator.
SPACe - field separator: space.
If the fourth optional parameter is omitted, semicolons are used.
Example: See MMEMory:LOAD:TRACe
Usage: Setting only
Manual operation: See "Save" on page 392
MMEMory:STORe:TRACe:CHANnel <Channel>, <TraceFile>[, <FormatInd>[,
<Format>[, <DecSeparator>[, <FieldSeparator>]]]]
Stores the trace data of all data traces in the specified channel to a trace file. Traces
are created using the CALCulate<Ch>:PARameter:SDEFine command.
Tip:*.s<n>p Touchstone files (<n> = 1, 2, 3, ...) are intended for a complete set of
<n>-port S-parameters. Data export fails if the active channel does not contain the full
set of <n>
2
traces.
Setting parameters:
<Channel> Channel number in the active channel setup. ALL means that a
separate file is created for each channel in the active channel
setup.
<TraceFile> String parameter to specify the name and directory of the cre-
ated trace file. Several file formats for trace files are supported.
The file extensions *.s<n>p, *.csvc, and *.dat for Touch-
stone, ASCII, and Matlab files are mandatory. To generate a
multiport Touchstone file *.s2p, *.s3p..., the channel must
contain traces for the full set of S-parameters. If no path is
specified the analyzer uses the
C:\Users\Public\Documents\Rohde-Schwarz\ZNL\
Traces directory.
VNA command reference
To Next Page
Loading...
